退火对TiO2薄膜形貌、结构及光学特性影响

利用射频磁控溅射技术在熔融石英基片上制备TiO<,2>薄膜,采用X射线衍射、扫描电子显微镜(SEM)、拉曼光谱以及透过谱研究了退火温度和退火气氛对TiO<,2>薄膜的结构、形貌和光学特性的影响.实验结果表明:在大气环境下退火,退火温度越.高,薄膜晶化越好,晶粒明显长大,温度高于700℃退火的薄膜,金红石相已明显形成.实验还发现,退火气氛对金红石相的形成是非常重要的,拉曼光谱反应出Ar气氛退火,抑制了金红石晶相的发育,薄膜仍以锐钛矿相为主.Ar气氛退火的薄膜在可见光范围内的透过率比大气退火的要低,并且由透过率曲线推知:金红石的光学带隙约为2.8 eV,比锐钛矿的光学带隙小0.2 eV.     

磁控溅射制备的W,WSi2,Si单层膜和W/Si,WSi2/Si多层膜应力

采用直流磁控溅射技术制备了厚度约100 nm的W,WSi2,Si单层膜和周期约为20 nm,Si膜层厚度与周期的比值为0.5的W/Si,WSi2/Si周期多层膜.利用台阶仪对镀膜前后基底表面的面形进行了测试,计算并比较了不同膜系的应力值.结果表明:W单层膜表现出较大的压应力,而W/Si周期膜则表现为张应力.WSi2单层...     

Effect of substrate temperature on microstructure and optical properties of single-phased Ag20 film deposited by using radio-frequency reactive magnetron sputtering method

Using a radio-frequency reactive magnetron sputtering technique, a series of the single-phased Ag20 films are deposited in a mixture of oxygen and argon gas with a flow ratio of 2：3 by changing substrate temperature （Ts）. Effects of the Ts on the microstructure and optical properties of the films are investigated by using X-ray diffractometry, scanning electron microscopy and spectrophotometry. The single-phased Ag20 films deposited at values of Ts below 200℃ are （111） preferentially oriented, which may be due to the smallest free energy of the （111） crystalline face. The film crystallization becomes poor as the value of Ts increases from 100℃ to 225℃. In particular, the Ag20 film deposited at Ts=225℃ loses the （111） preferential orientation. Correspondingly, the film surface morphology obviously evolves from a uniform and compact surface structure to a loose and gullied surface structure. With the increase of Ts value, the transmissivity and the reflectivity of the films in the transparent region are gradually reduced, while the absorptivity gradually increases, which may be attributed to an evolution of the crystalline structure and the surface morphology of the films.     

Effect of environment and heat treatment on the optical properties of RF-sputtered SnO2 thin films

Thin films of SnO₂ were deposited by RF-magnetron sputtering on quartz substrates at room temperature in an environment of Ar and O₂. The XRD pattern shows amorphous nature of the as-deposited films. The optical properties were studied using the reflectance and transmittance spectra. The estimated optical band gap (E_g) values increase from 4.15 to 4.3 eV as the Ar gas content decreases in the process gas environment. The refractive index exhibits an oscillatory behavior that is strongly dependent on the sputtering gas environment. The Urbach energy is found to decrease with increase in band gap. The band gap is found to decrease on annealing the film. The role of oxygen defects is explored in explaining the variation of optical parameters.     

Influence of deposition temperature on the crystallinity of Al-doped ZnO thin films at glass substrates prepared by RF magnetron sputtering method

Al-doped ZnO (AZO) transparent conducting films were successfully prepared on glass substrates by RF magnetron sputtering method under different substrate temperatures. The microstructural, electrical and optical properties of AZO films were investigated in a wide temperature range from room temperature up to 350 °C by X-ray Diffraction (XRD), Field-Emission Scanning Electron Microscopy (FESEM), High-Resolution Transmission Electron Microscopy (HRTEM), Hall measurement, and UV–visible meter. The nature of AZO films is polycrystalline thin films with hexagonal wurtzite structure and a preferred orientation along c-axis. The crystallinity and surface morphologies of the films are strongly dependent on the growth temperature, which in turn exerts a great effect on microstructural, electrical and optical properties of the AZO films. The atomic arrangement of AZO film having an wurtzite structure was indeed identified by the HRTEM as well as the Selected Area Electron Diffraction (SAED). The defect density of AZO film was investigated by HRTEM. The film deposited at 100 °C exhibited the relatively well crystallinity and the lowest resistivity of 3.6 × 10⁻⁴ Ω cm. The average transmission of AZO films in the visible range is all over 85%. More importantly, the low-resistance and high-transmittance AZO film was also prepared at a low temperature of 100 °C.     

Bi-Sb-Te基热电薄膜温差电池离子束溅射制备与表征

本文采用离子束溅射Bi/Te和Sb/Te二元复合靶,直接制备n型Bi₂Te₃热电薄膜和p型Sb₂Te₃热电薄膜.在退火时间同为1 h的条件下,对所制备的Bi₂Te₃薄膜和Sb₂Te₃薄膜进行不同温度的退火处理,并对其热电性能进行表征.结果表明,在退火温度为150 ℃时,制备的n型Bi₂Te₃关键词： 薄膜温差电池 2Te₃薄膜')" href="#">Sb₂Te₃薄膜 2Te₃薄膜')" href="#">Bi₂Te₃薄膜 离子束溅射     

纳米VOx薄膜在空气中的电学特性退化研究

采用射频磁控溅射法在氮化硅衬底上沉积纳米VO_x薄膜,利用X射线衍射、原子力显微镜分别对薄膜的结晶形态及表面形貌进行表征.研究了纳米VO_x薄膜在空气中长时间暴露后的方块电阻、热滞回线等电学特性的变化情况,并分析这些变化给器件带来的影响.利用X射线光电子能谱仪、傅里叶变换红外光谱仪分析对比新制与久置薄膜的组分及分子结构差异.研究表明,暴露在空气中的纳米VO_x薄膜方块电阻增大是因为低价钒离子被吸附氧原子氧 关键词： x薄膜')" href="#">纳米VO_x薄膜 磁控溅射 电学特性 退化     

O2流量对磁控溅射N掺杂TiO2薄膜成分及晶体结构的影响

利用直流脉冲磁控溅射方法在室温下通过改变O₂流量制备具有不同晶体结构的N掺杂TiO₂薄膜,利用台阶仪、X射线光电子能谱仪、X射线衍射仪、紫外-可见分光光度计等设备对薄膜沉积速率、化学成分、晶体结构、禁带宽度等进行分析.结果表明:所制备的薄膜元素配比约为TiO_1.68±0.06N_0.11±0.01,N为替位掺杂,所有样品退火前后均未形成Ti—N相结构,N掺杂TiO₂薄膜的沉积速率、晶体结构等主要依赖于O₂流量.在O₂流量为2 sccm时,N掺杂TiO₂薄膜沉积速率相对较高,薄膜为非晶态结构,但薄膜内含有锐钛矿(anatase)和金红石(rutile)相晶核,退火后薄膜呈anatase和rutile相混合结构,禁带宽度仅为2.86 eV.随着O₂流量的增加,薄膜沉积速率单调下降,退火后样品禁带宽度逐渐增加.当O₂流量为12 sccm时,薄膜为anatase相择优生长,退火后呈anatase相结构,禁带宽度为3.2 eV.综合本实验的分析结果,要在室温条件下制备晶态N掺杂TiO₂薄膜,需在高O₂流量(＞10 sccn)条件下制备. 关键词： 2薄膜')" href="#">N掺杂TiO₂薄膜 磁控溅射 化学配比 晶体结构     

Composition, microstructure, and properties of CrNx films deposited using medium frequency magnetron sputtering

CrN_x films were deposited on stainless steel and Si (1 1 1) substrates via medium frequency magnetron sputtering in a N₂ + Ar mixed atmosphere. The influence of N₂ content on the deposition rate, composition, microstructure, mechanical and tribological properties of the as-deposited films was investigated by means of the X-ray photoelectron spectrometry (XPS), X-ray diffraction (XRD), field emission scanning electron microscope (FESEM), nanoindentation and tribometer testing. It was found that the N atomic concentration increased and the phase transformed from a mixture of Cr₂N + Cr(N) to single-phase Cr₂N, and then Cr₂N + CrN to pure CrN phase with the increase of N₂ content. The Cr 2p_3/2 and N 1s of XPS spectra also confirmed the evolution of phase. Accordingly, all films exhibited a typical columnar structure which lies in the zone T of Thornton Model. The mixed Cr₂N and Cr(N) phases showed low hardness and high friction coefficient. Cr₂N possessed higher hardness than CrN while CrN exhibited lower friction coefficient.     

Structural and optical properties of RF magnetron sputtered aluminum nitride films without external substrate heating

We report structural and optical properties of aluminum nitride (AlN) thin films prepared by RF magnetron sputtering. A ceramic AlN target was used to sputter deposit AlN films without external substrate heating in Ar-N₂ (1:1) ambient. The X-ray diffraction and high resolution transmission electron microscopy results revealed that the films were preferentially oriented along c-axis. Cross-sectional imaging revealed columnar growth perpendicular to the substrate. The secondary ion mass spectroscopy analysis confirmed that aluminum and nitrogen distribution was uniform within the thickness of the film. The optical band gap of 5.3 eV was evaluated by UV-vis spectroscopy. Photo-luminescence broad band was observed in the range of 420-600 nm with two maxima, centered at 433 nm and 466 nm wavelengths related to the energy states originated during the film growth. A structural property correlation has been carried out to explore the possible application of such important well oriented nano-structured two-dimensional semiconducting objects.